Insert Roller

Series 1000

Ensure safe product accumulation with the Intralox Series 1000 Insert Roller belt.

Used across many industries—especially beverage—S1000 Insert Roller belting offers low back pressure accumulation to prevent product damage from packaging to palletizing. It features a 0.60-in (15.2-mm) pitch that provides exceptional tight transfer capability and eliminates the need for dead plates.

Groups of three rollers in 3-in (76.2-mm) increments improve product control and stability
Superior belt strength allows accumulation and acceleration on a single conveyor
Small pitch minimizes chordal rise and decline
0.75-in (19.1-mm) nose-roller transfers

	in	mm
Pitch	0.60	15.2
Minimum Width	9	228
Width Increments	3.00	76
Open Area	12.5%
Hinge Style	Closed
Rod Retention; Rod Type	Barn door; unheaded

Contact Intralox for precise belt measurements and stock status before designing equipment or ordering a belt.
Has fully flush edges on one side and closed edges on opposite side.
Rollers protrude above and below the belt surface.
Each belt material has a default rod material. Other rod materials are available. Intralox can help identify the best belt and rod material combination for your application.
Detailed material information is provided in Product Line.
Roller density: 240 rollers/ft² (2580 rollers/m²).
Minimal back tension required for sprocket engagement
Compatible with 0.75 in (19.1 mm) diameter notched nosebars for tight transfers. Contact Intralox Customer Service for more information.
Belt can be supported using 1.38 in (35.1 mm) wide or narrower parallel wearstrips.
For low back-pressure applications, place wearstrip between rollers. For activated roller applications, place wearstrip directly under rollers.
Yellow acetal rollers are 0.3 in (7.6 mm) wide and 0.48 in (12.1 mm) diameter. Rollers are on the belt rod.
Rollers are spaced in groups with 1.5 in (38.1 mm) between roller zones.
Roller indent from edge of belt to edge of roller: 2.25 in (57.2 mm).
Sprocket locations are indented 1.5 in (38.1 mm) from edge of belt.
Sprocket locations are 3.0 in (76.2 mm) apart.