Belt Finder

S8050 Ribbed V-Top™ E (9.5 mm) Polyurethane

Series 8050
Request a Quote

Elevate bulk product on moderate inclines with the Intralox Series 8050 Ribbed V-Top (9.5 mm) belt in polyurethane.  

Part of our BarDrive product line, this belting features a full-width drive bar that maximizes belt pull. Its tensionless, positive-drive system reduces downtime and eases maintenance in heavily loaded, direct food–contact applications.

The belt is made of a wear-resistant, easy-to-clean polyurethane material. Raised arrow-shaped protrusions across its surface prevent small products like frozen berries or pizza toppings from sliding back on inclines up to 30 degrees. This design reduces product loss or damage and eliminates the need for flights. 

  • Pair with Intralox ZeroSplice technology to eliminate splicing needs
  • Homogeneous thermoplastic structure streamlines installation
  • Lightweight, hinge-free belting improves sanitation 
  • Arrow-shaped protrusions allow for scraper and limiter use
inmm
Pitch1.95649.68
Overall Thickness0.3749.5
Minimum Width251
Maximum Width421,067
Minimum Backbend Diameter4.0102
Minimum Sprocket Diameter (10T)6.5165
Open Area (seamless surface)0%
Available Joining Optionsprepared ends, endless, ThermoLace HDE
Available Colorsblue

  • Contact Intralox for precise belt measurements and stock status before designing equipment or ordering a belt.
  • Enables bulk product conveyance on inclines up to 30 degrees without using flights.
  • Allows improved product release and removal at discharge.
  • ThermoLace HDE joint is Flat Top for up to 12 in (305 mm) across hinge rod.
  • Spliced joint is Flat Top for less than 1 in (25 mm) across splice.
  • Splicing requires ThermoDrive Belt End Router and square spacers available from Intralox.
  • See Material Compliance for compliance details.

Belt MaterialMaximum Belt Pull Capability1,2,3Temperature Range (continuous)4 Belt Weight
lbf/ft widthN/m width°F°Clb/ft2kg/m2
Polyurethane1802,62720 to 140-7 to 600.9874.82

  1. With sprockets spaced on 3 in (76 mm) centers; Consider using stacked sprockets for optimal operational performance in heavily loaded applications

  2. For continuous use over 100°F (38°C), contact Intralox Customer Service for actual belt pull capability.

  3. For ThermoLace HDE-specific strength ratings, see S8050 ThermoLace with Heavy-Duty Edge Joining.

  4. Polyurethane exhibits increased stiffness at temperatures below 40°F (5°C). Not recommended for applications requiring small component diameters with operating temperatures below 40°F (5°C).

Series 8050