Radius with Edge Bearing

Series 2400

Prevent unexpected downtime in heavily loaded, high-speed applications with the Intralox Series 2400 Radius with Edge Bearing belt.

This belt has edge bearings that replace sliding friction with rolling friction, reducing tension in high-speed turns to reliably transport heavy loads. Its large open area simplifies cleaning, and its modular plastic design ensures straightforward installation and maintenance.

42% open area
Bearings recommended exclusively for dry applications
Bearings reserved for inside edges of turns
Minimum turn radius of 2.2 times belt width

	in	mm
Pitch	1.00	25.4
Minimum Width (Bearings One Side)	7.5	191
Minimum Width (Bearings Both Sides)	9.0	229
Maximum Width	36	914
Width Increments	0.5	12.7
Opening Size (approximate)	0.35 x 0.30	8.9 x 7.6
Open Area	42%
Product Contact Area	23%
Hinge Style	Open
Rod Retention; Rod Type	Occluded edge; unheaded

Contact Intralox for precise belt measurements and stock status before designing equipment or ordering a belt.
Occluded edge rod retention allows for easier insertion and removal of rods.
Edge bearings are only available for turning belts.
Edge bearings are stainless steel and are retained by a plastic pin.
Edge bearings are available on one side (for belts that turn in only one direction) or on both sides (for belts that turn in both directions). Bearings must be placed on the inside edge of the turn, and must be configured in every other row of the belt.
Both flush edge and hold down guide edge are available for belts that have bearings on only one side and must be placed on the outside edge of the turn.
Each belt material has a default rod material. Other rod materials are available. Intralox can help identify the best belt and rod material combination for your application.
Detailed material information is provided in Product Line.
Designed for radius applications with a turn radius of 2.2 times the belt width.

Belt Material	Default Rod Material, Diameter 0.18 in (4.6 mm)	Straight Belt Strength		Curved Belt Strength						Temperature Range (continuous)		Belt Mass
Belt Material	Default Rod Material, Diameter 0.18 in (4.6 mm)	lbf/ft	N/m	Curved Belt Strength						°F	°C	lb/ft²	kg/m²
Acetal	Nylon	1,700	24,800	For curved belt strength calculations, contact Intralox Customer Service.						0 to 200	-18 to 93	1.59	7.76