Radius Flush Grid High Deck with Heavy-Duty Edge

Series 2400

Prevent snagging or disorientation of wide products with the Intralox Series 2400 Radius Flush Grid High Deck with Heavy-Duty Edge (HDE) belt.

Part of the industry’s most dependable radius series, the S2400 Radius Flush Grid High Deck HDE belt allows products to extend beyond its width without snagging. It has a Load-Sharing edge that distributes stress to minimize fatigue failures, and molded-in arrows on edges that indicate proper run direction.

Smaller belt edge opening area reduces catchpoints
Fault-tolerant edge design protects against edge breakage
Greater open area offers superior cleanability
High Deck style stabilizes heavier boxes and crate loads

	in	mm
Pitch	1.00	25.4
Minimum Width	4	101.6
Width Increments	0.5	12.7
Opening Size (approximate)	0.35 x 0.30	8.9 x 7.6
Open Area	42%
Product Contact Area	23%
Hinge Style	Open
Rod Retention; Rod Type	Occluded edge; unheaded

Contact Intralox for precise belt measurements and stock status before designing equipment or ordering a belt.
Heavily reinforced and carefully sculpted edge is designed to resist belt snagging and edge damage while maintaining cleanability.
Flush edge features an intuitive molded-in arrow to indicate preferred run direction, and extensions to reduce finger entrapment.
Load-Sharing^™ belt edge improves how the load is shared and minimizes belt fatigue failure.
Belt openings pass straight through the belt to simplify cleaning.
Sprocket drive system minimizes wear and requires low return-side tension.
Each belt material has a default rod material. Other rod materials are available. Intralox can help identify the best belt and rod material combination for your application.
Detailed material information is provided in Product Line.
Makes turns with an inside radius of 2.2 times the belt width
Radius belt wearstrips are available.
Contact Intralox Customer Service before using a belt wider than 36 in (914 mm) in flat-turning or spiral applications.
Flush Grid High Deck is 0.4 in (10 mm) higher than the standard S2400 belt.
Standard indent: 0.875 in (22.2 mm)
Minimum nosebar diameter: 1.375 in (34.9 mm)

Belt Material	Default Rod Material, Diameter 0.18 in (4.6 mm)	Belt Strength		Curved Belt Strength	Temperature Range (continuous)		Belt Mass
Belt Material	Default Rod Material, Diameter 0.18 in (4.6 mm)	lbf/ft	N/m	Curved Belt Strength	°F	°C	lb/ft²	kg/m²
Polypropylene	PK	1,200	17,500	For curved belt strength calculations, contact Intralox Customer Service.	34 to 176	1 to 80	1.90	9.28
Acetal	PK	1,700	24,800		-40 to 176	-40 to 80	2.83	13.82
HR Nylon	HR Nylon	1,700	24,800		-50 to 240	-46 to 116	2.3	11.23
PK	PK	1,700	24,800		-40 to 176	-40 to 80	2.49	12.16