Radius Flush Grid (2.4) with Insert Rollers

Series 2400

Contact Intralox for precise belt measurements and stock status before designing equipment or ordering a belt.
Uses acetal rollers.
Each belt material has a default rod material. Other rod materials are available. Intralox can help identify the best belt and rod material combination for your application.
Detailed material information is provided in Product Line.
For radius applications requiring low back pressure accumulation with minimum radius of 2.4 times belt width (measured from inside edge).
For low back pressure applications, place wearstrip between rollers. For driven applications, place wearstrip directly under rollers.
Do NOT place sprockets in line with rollers.
Belts 12 in (305 mm) wide and less have a turn ratio of 1.7.
Contact Intralox Customer Service before using a belt width greater than 24 in (610 mm) in a flat turning or spiral applications.
Standard roller width spacings: 2 in (51 mm), 3 in (76 mm) or 4 in (102 mm).
Standard roller row spacings: 2 in (51 mm) or 4 in (102 mm).
Roller indents: 3.5 in (89 mm) or 4 in (102 mm) based on roller width spacing selected.

Belt Material	Default Rod Material, Diameter 0.18 in (4.6 mm)	Straight Belt Strength		Roller Indents		Curved Belt Strength	Temperature Range (continuous)		Belt Mass
Belt Material	Default Rod Material, Diameter 0.18 in (4.6 mm)	lbf/ft	N/m	in	mm	Curved Belt Strength	°F	°C	lb/ft²	kg/m²
Polypropylene	Acetal	500	7,300	3.5 or 4.0	89 or 102	For curved belt strength calculations, contact Intralox Customer Service.	34 to 200	1 to 93	1.20	5.86
Acetal	Nylon	500	7,300	3.5 or 4.0	89 or 102		-50 to 200	-46 to 93	1.73	8.44
Polypropylene	Polypropylene	500	7,300	3.5 or 4.0	89 or 102		34 to 220	1 to 104	1.12	5.47