Flush Grid High Deck with Load-Sharing™ Edge

Series 2400

Eliminate product snagging and disorientation with the Intralox Series 2400 Flush Grid High Deck with Load-Sharing Edge belt.

This belt prevents contact between the wearstrip and products, allowing them to span and extend beyond the belt’s full width without snagging. Part of the industry’s most dependable radius series, it has a Load-Sharing edge that distributes stress to minimize fatigue failures. Its 0.4-in (10.2-mm) raised surface can cushion products at transfer sites, reducing damage risk.

0.875-in (22.2-mm) raised surface indent
42% open area simplifies cleaning
Load-Sharing edge extends belt life
Minimum turn radius of 2.2 times belt width

	in	mm
Pitch	1.00	25.4
Minimum Width	10.5	266.7
Maximum Width	36	914
Width Increments	0.5	12.7
Opening Size (approximate)	0.35 x 0.30	8.9 x 7.6
Open Area	42%
Product Contact Area	23%
Hinge Style	Open
Rod Retention; Rod Type	Occluded edge; unheaded

Contact Intralox for precise belt measurements and stock status before designing equipment or ordering a belt.
Belt openings pass straight through the belt to simplify cleaning.
Flush edge design features an extension to reduce the opening size.
Load-Sharing belt edge improves how the load is shared and minimizes fatigue failure in various areas of the belt.
Each belt material has a default rod material. Other rod materials are available. Intralox can help identify the best belt and rod material combination for your application.
Detailed material information is provided in Product Line.
Sprocket drive system minimizes wear and requires very low return-side tension.
Designed for radius applications with a turn radius of 2.2 times the belt width.
Uses a standard S2400 wearstrip.
Standard indent: 0.875 in (22.2 mm).
Load-Sharing Edge height: 0.4 in (10 mm) higher than the standard S2400 belt.

Base Belt Material	Default Rod Material, Diameter 0.18 in (4.6 mm)	Straight Belt Strength		Curved Belt Strength	Temp. Range (continuous)¹		Belt Mass
Base Belt Material	Default Rod Material, Diameter 0.18 in (4.6 mm)	lbf/ft	N/m	Curved Belt Strength	°F	°C	lb/ft²	kg/m²
Polypropylene	Acetal	1,200	17,500	For curved belt strength calculations, contact Intralox Customer Service.	34 to 200	1 to 93	1.90	9.28
Acetal	Nylon	1,700	24,800		-50 to 200	-46 to 93	2.83	13.82
Polypropylene	Polypropylene	1,000	14,600		34 to 200	1 to 104	1.84	8.99