Flush Grid Nose-Roller Tight Turning

Series 2300

Efficiently transport packaged goods in radius applications with the Intralox Series 2300 Flush Grid Nose-Roller Tight Turning belt.

This belt features an exceptional turn ratio that provides plant layout flexibility. It eliminates the need for dead plates and includes a Load-Sharing edge that distributes stress across modules to minimize fatigue failures.

Minimum turn radius of 1.7 times belt width for widths up to 27 in (685.8 mm)
Unheaded rod retention system eases maintenance
Sprockets feature large lug teeth that extend sprocket life
0.75-in (19.1-mm) nose-roller transfers

	in	mm
Pitch	1.0	25.4
Minimum Width	12.0	305
Maximum Width	36.0	914
Width Increments	3.0	76.2
Maximum Opening Size (Sphere)	0.245	6.2
Open Area (fully extended)	28%
Hinge Style	Closed
Rod Retention; Rod Type	Occluded edge; unheaded

Contact Intralox for precise belt measurements and stock status before designing equipment or ordering a belt.
Smooth upper surface provides free product movement.
Smaller opening size enhances belt safety
The underside design allows the belt to run smoothly around a 0.75 in (19.1 mm) nosebar.
Available with tight turning modules built on one side.
Each belt material has a default rod material. Other rod materials are available. Intralox can help identify the best belt and rod material combination for your application.
Detailed material information is provided in Product Line.
Sprockets have large lug teeth that enhance sprocket life.
Designed for sideflexing applications with a standard turn radius of 1.7 times belt width (measured from inside edge) for belt widths up to 27.0 in (686 mm). The standard turn radius is 1.75 times belt width for 30.0 in (762 mm) wide belts, 1.8 times belt width for 33-36.0 in (838-914 mm) wide belts.
Minimum turn radius information is available in the S2300 Conveyor Design Guidelines. Contact Intralox Customer Service for more information.
Can make 180 degree turns
Belts can turn either clockwise or counterclockwise. Turning direction must be specified at order. Not available for S-turn applications.
Detailed conveyor design guidelines are available. Contact Intralox Customer Service for more information.
Minimizes floor space requirements.
Minimal back tension required for sprocket engagement
Sprocket placement: every 3.00 in (76.2 mm) from outer edge, except drive pocket nearest inner edge. Drive pocket nearest inner edge is 3.75 in (95.3 mm) from the inner edge.

Belt Material	Default Rod Material, Diameter 0.18 in (4.6 mm)	Straight Belt Strength		Curved Belt Strength		Temp. Range (continuous)		Belt Mass
Belt Material	Default Rod Material, Diameter 0.18 in (4.6 mm)	lbf/ft	N/m	Curved Belt Strength		°F	°C	lb/ft²	kg/m²
Acetal	Nylon	900	13,100	For curved belt strength calculations, contact Intralox Customer Service.		-50 to 200	-46 to 93	2.40	11.72