Flush Grid Nose-Roller Dual Turning

Series 2300

Efficiently transport packaged goods in applications that require both left and right turns with the Intralox Series 2300 Flush Grid Nose-Roller Dual Turning belt.

The S2300 Flush Grid Nose-Roller Dual Turning belt accommodates 180-degree curves with ease. It eliminates the need for dead plates and includes a Load-Sharing edge that distributes stress across modules to minimize fatigue failures.

Minimum turn radius of 2.2 times belt width for widths up to 27 in (685.8 mm)
Ability to perform dual turns ensures optimal use of plant space
Unheaded rod retention system eases maintenance
Sprockets feature large lug teeth that extend sprocket life
0.75-in (19.1-mm) nose-roller transfers

	in	mm
Pitch	1.00	25.4
Minimum Width	12	305
Maximum Width	36	914
Width Increments	3	76.2
Opening Size (Sphere)	0.245	6.2
Open Area	28%
Hinge Style	Closed
Rod Retention; Rod Type	Occluded edge; unheaded

Contact Intralox for precise belt measurements and stock status before designing equipment or ordering a belt.
Use the Intralox® Engineering Program to determine the strength requirement of most radius applications and ensure the belt is strong enough for the application.
Minimizes floor space requirements.
Can be used in S-turn applications.
Unheaded rods simplify maintenance.
The underside design allows the belt to run smoothly around a 0.75-in (19.1 mm) nosebar.
Each belt material has a default rod material. Other rod materials are available. Intralox can help identify the best belt and rod material combination for your application.
Detailed material information is provided in Product Line.
Designed for sideflexing applications with a minimum turn radius of 2.2 times belt width (measured from inside edge) for widths up to 27.0 in (686 mm). The standard turn radius is 2.3 times the belt width for 30-36.0 in (762-914 mm) wide belts.
Minimum turn radius information is available in the S2300 Conveyor Design Guidelines. Contact Intralox Customer Service for more information.
Detailed conveyor design guidelines are available. Contact Intralox Customer Service for more information.
Sprockets have large lug teeth that enhance sprocket life.
Sprocket placement: every 3.00 in (76.2 mm) from outer edge, except drive pocket nearest flush edge. Drive pocket nearest flush edge is 3.75 in (95.3 mm) from belt edge.

Belt Material	Default Rod Material, Diameter 0.18 in (4.6 mm)	Straight Belt Strength		Curved Belt Strength						Temperature Range (continuous)		Belt Mass
Belt Material	Default Rod Material, Diameter 0.18 in (4.6 mm)	lbf/ft	N/m	Curved Belt Strength						°F	°C	lb/ft²	kg/m²
Acetal	Nylon	900	13,100	For curved belt strength calculations, contact Intralox Customer Service.						-50 to 200	-46 to 93	2.40	11.72