Radius with Edge Bearing
Series 2200| in | mm | |
| Pitch | 1.50 | 38.1 |
| Minimum Width (Bearings one side) | 7 | 178 |
| Minimum Width (Bearings both sides) | 9 | 229 |
| Width Increments | 1.00 | 25.4 |
| Opening Size (approximate) | 0.50 x 0.75 | 12.7 x 19.7 |
| Open Area | 50% | |
| Product Contact Area | 37% | |
| Hinge Style | Open | |
| Rod Retention; Rod Type | Occluded edge; unheaded | |
- This belt has pinch points. See the Safety section in the Intralox Conveyor Belting Installation, Maintenance & Troubleshooting Manual for more information.
- Contact Intralox for precise belt measurements and stock status before designing equipment or ordering a belt.
- Both flush edge and tab edge are available for belts with bearings on only one side. Flush edge and tab edge must be placed on the outside edge of the turn.
- Rod retention allows for easier insertion and removal of rods.
- Edge bearings are only available for turning belts.
- Bearings are available on one side for belts that turn in only one direction or on both sides for belts that turn in both directions.
- Bearings must be configured in every other row of the belt.
- Bearings are chrome steel, recommended for dry applications only.
- Bearings are retained with a stainless pin.
- Each belt material has a default rod material. Other rod materials are available. Intralox can help identify the best belt and rod material combination for your application.
- Detailed material information is provided in Product Line.
- Bearings must be placed on the inside edge of the turn.
- Designed for radius applications with a minimum turn radius of 2.2 times the belt width (measured from the inside edge of the wearstrip channel).
- Use the Intralox Engineering Program to determine if edge bearings are suitable for the intended application.
- Maximum belt speed: 350 fpm (107 mpm).
- The plastic portion of the bearing edge is indented 0.125 in (3.2 mm). Belt width is measured to the end of the bearing.
- Belts with bearings on one side work with standard edge, hold down wearstrips with a 0.50 in (12.7 mm) deep channel.
- Belts with bearings on both sides require the wearstrip on the outside of the turns to have at least a 0.75 in (19.1 mm) deep channel.
- Maximum belt width: 36 in (914 mm).
| Belt Material | Default Rod Material, Diameter 0.24 in (6.1 mm) | Straight Belt Strength | Curved Belt Strength | Temperature Range (continuous) | Belt Mass | ||||
|---|---|---|---|---|---|---|---|---|---|
| lbf/ft | N/m | °F | °C | lb/ft² | kg/m² | ||||
| Acetal | Nylon | 2,000 | 29,200 | For curved belt strength calculations, contact Intralox Customer Service. | -50 to 200 | -46 to 93 | 2.82 | 13.80 | |
