Belt Finder

Nub Top™

Series 1600
Request a Quote
inmm
Pitch1.0025.4
Minimum Width5127
Width Increments0.5012.7
Open Area0%
Product Contact Area10%
Hinge StyleOpen
Rod Retention; Rod TypeOccluded edge; unheaded

  • Contact Intralox for precise belt measurements and stock status before designing equipment or ordering a belt.
  • Closed upper surface with fully flush edges.
  • Each belt material has a default rod material. Other rod materials are available. Intralox can help identify the best belt and rod material combination for your application.
  • Detailed material information is provided in Product Line.
  • Not recommended for product accumulation conditions. Contact Intralox Customer Service for information about friction values between product and belt.
  • Standard flights available in polypropylene, polyethylene, and acetal. Flights are molded as part of the belt, and can be cut to any size.
  • Recommended for products large enough to span the distance between the nubs [0.250 in (6.35 mm)].
  • Standard nub indent: 1.3 in (33.0 mm).
  • Flight height: 4 in (102 mm).

Belt MaterialDefault Rod Material, Diameter 0.18 in (4.6 mm)Belt StrengthTemperature Range (continuous)Belt Mass
lbf/ftN/m°F°Clb/ft²kg/m²
PolypropylenePolypropylene70010,20034 to 2201 to 1041.135.52
PolyethylenePolyethylene3505,110-50 to 150-46 to 661.185.76
AcetalPolypropylene1,40020,40034 to 2001 to 931.748.49
AcetalPolyethylene11,00014,600-50 to 150-46 to 661.748.49
X-ray detectable acetalX-ray detectable acetal1,40020,400-50 to 200-46 to 932.019.81

  1. Polyethylene rods can be used in cold applications when impacts or sudden starts/stops occur. Please note lower rating.

Series 1600