| in | mm | |
| Pitch | 2.0 | 50.8 |
| Minimum Width | 15 | 381 |
| Maximum Width | 44 | 1,118 |
| Width Increments | 1.0 | 25.4 |
| Opening Size (approximate) | 0.85 × 0.88 | 21.6 × 22.5 |
| Open Area (fully extended) | 56% | |
| Minimum Open Area (1.1 turn ratio) | 22% | |
| Hinge Style | Open | |
| Rod Retention; Rod Type | Occluded edge; unheaded | |
- This belt has pinch points. See the Safety section in the Intralox Conveyor Belting Installation, Maintenance & Troubleshooting Manual for more information.
- Contact Intralox for precise belt measurements and stock status before designing equipment or ordering a belt.
- Lightweight, relatively strong belt with smooth surface grid.
- Belt openings pass straight through the belt to simplify cleaning.
- Each belt material has a default rod material. Other rod materials are available. Intralox can help identify the best belt and rod material combination for your application.
- Detailed material information is provided in Product Line.
- Designed for low-tension, capstan drive spiral applications with a minimum turn radius of 1.1 times the belt width (measured from inside edge).
- For belt widths under 15 in (381 mm) and over 44 in (1118 mm), contact Intralox Customer Service.
- Contact Intralox Customer Service for preferred run direction on spiral applications.
- Minimum sprocket indent from the inside (collapsed) edge of the spiral: 9.0 in (228.6 mm).
| Belt Material | Default Rod Material, Diameter 0.24 in (6.1 mm) | Straight Belt Strength | Spiral Belt Strength1 | Temperature Range (continuous) | Belt Mass | ||||
|---|---|---|---|---|---|---|---|---|---|
| lbf/ft | N/m | lbf | N | °F | °C | lb/ft² | kg/m² | ||
| Acetal | Acetal | 1,300 | 19,000 | 300 | 1,330 | -50 to 200 | -46 to 93 | 1.44 | 7.03 |
| SELM | Acetal | 1,100 | 16,100 | 300 | 1,330 | -50 to 200 | -46 to 93 | 1.24 | 6.05 |
Published spiral belt strengths and their method of calculation vary among belt manufacturers. Please consult an Intralox spiral engineer for accurate comparison of spiral belt strengths.
